The use of UV aging test chamber should pay attention to:

1. Keep it dry during non-working period, cut off the power supply

2. During the operation of the equipment, it is necessary to maintain sufficient water source.

3. The time for opening the box door should be minimized during the test phase;

4. After the test, drain the water inside the test machine and dry it;

5. Keep the appearance of the cabinet clean and tidy to prevent dust from intruding into the cabinet;

4. Non-professional operators are not allowed to operate at will;

5. If the equipment does not solve the problem, please contact the company;

5 After stopping the use for a long time, if you need to use it again, you must carefully check the water source, power supply and various components, and then start the equipment after confirming that it is correct;

6 Because ultraviolet radiation has a strong hazard to people (especially the eyes), operators should minimize exposure to ultraviolet light (contact time should be <1min). Operators are advised to wear protective eyepieces and jackets.

UV aging test chamber maintenance:

1. Avoid external force hitting the box;

2. The laboratory maintains a dry environment;

3. Prohibit the exposure of chemicals to this equipment;

4. It is absolutely forbidden to set the temperature to exceed the maximum temperature specified by the equipment;

5. Check the circuit control system once before each power-on;

6. Confirmation of power supply and grounding wire;

7. The power cable is properly connected according to the specifications and is grounded.

8. Check the over-temperature protector, if it has been set (it has been adjusted at the factory, generally no adjustment is needed);

9. The ventilation fan should be installed in the laboratory to keep the room ventilated;

10. Pay attention to the water level of the water tank during the spray test and replenish the purified water in time;

11. The wastewater discharge system of the equipment must be installed in place;

12. After the test is over, cut off the power of the whole machine;

13. After each test, the sample should be taken out and the equipment liner cleaned up;

14. Non-professionals are strictly prohibited to operate this equipment.

X Ray Reverse Wearing Lead Clothing

Reverse Vest & Skirt,X Ray Back Fasten Lead Clothing,X Ray Lead Gown,Lightweight Lead Clothing

Longkou Kangxie Medical Instrument Co., Ltd , https://www.lkkangxiemedical.com