In the maintenance of the tractor, in addition to doing external and internal cleaning, the cleaning of special parts such as filters, cooling systems, and lubrication systems should also be done. 1, foam plastic air filter cleaning. Remove the dust from the shell first, and place the filter in the detergent or soap solution (not gasoline). Wash the mash and allow it to dry. Soak the filter in a clean oil and squeeze it by hand. When replacing the filter, it must be immersed in oil. The width of the new filter should be 10mm higher than the core tube. Make each end of the filter 5mm longer than the core tube. The filter should be able to wind two times around the core tube, and both ends should be pressed under the bead. The length of the filter exposed on the outside of the bead should not exceed 3mm. When the filter cartridge assembly is installed on the housing, the direction of winding on the filter should be consistent with the direction of air flow. 2, paper filter cleaning. First use a rubber stopper to block the central orifice at both ends of the filter element. In the basin filled with diesel or kerosene, clean the inner hole of the filter element with a soft brush to inflate the dirt from the inside to the outside of the pores of the filter paper. Finally scrub again with clean diesel or kerosene. 3, use acid wash to clean the cooling system. First put a net cooling water, pour 25% hydrochloric acid solution, wait 10 minutes, make the scale off, dissolve, and then release the cleaning solution, rinse the cooling system with clean water. If the scale block in the cleaning liquid plugs the drain switch, the lower water pipe can be directly taken out to discharge the cleaning liquid. 4, wash with alkali to clean the cooling system. First, the net cooling water was drained, and a mixture of 6 kg of hot water, 0.5 kg of caustic soda, and 0.1 kg of kerosene was poured into a water tank. After standing for 2 hours, the engine was started for 10 minutes. After this interval of operation 5-6 times, the cleaning fluid is discharged with heat, and after the engine is slightly cold, the water tank and the water channel are cleaned with fresh water. 5, lubrication system cleaning. When the engine is at a standstill, the old oil is discharged hot, so that the impurities are discharged together with a random oil, and then the filter and drain plug are cleaned. In the crankcase, washing oil mixed with engine oil, kerosene, and diesel oil is added. After the engine runs at a low speed for 3-5 minutes, the washing oil is drained and the new engine oil is injected. In the cleaning should pay attention to the oil pressure must not be less than 50Pa. In addition, when the gearbox is cleaned, gear oil should also be warmly discharged, an appropriate amount of diesel oil should be added, and the tractor should advance and back several times to perform cleaning. Then discharge the diesel fuel and add the clean gear oil. Rongcheng Jingyi Oceanic Technology Company Limited , https://www.jingyifoods.cn