Feed crusher is a widely used processing machine in rural areas. It is mainly used for the processing of poultry, livestock and fishery feed. After some farm machinery buyers buy back feed machines, they do not conduct systematic overall inspection and commissioning of the whole machine of the feed machine, and they blindly put into operation. This is not safe and can easily cause human accidents. The correct operation and use methods are: 1, first of all to choose the crusher and power machine installation location. For long-term fixed operation, the unit should be fixed on the cement base; the unit must be firmly installed. Reliable without looseness; the two pulleys should be in a straight line and must not be skewed. 2. After the pedestal is completely solidified, perform static inspection of the unit repeatedly, systematically, and comprehensively, and then carry out dynamic idle load test run for 3-5 minutes. If there is no abnormal phenomenon, the unit can be put into formal operation. 3. If electricity is used for power, a professional electrician should be found to rationalize the layout of the line. Electricity lines and facilities should be standardized and neat, and should not be installed or improvised. 4. After the crusher is put into operation for about 10 days, the covers should be opened to inspect the rotors, hammers, and other moving parts, and the connected screw schools should be sturdy. Check whether the bearings are well lubricated. If there is any stagnation or rubbing phenomenon Should be eliminated promptly. 5, in the operation, we must carefully check the processing of materials, check for nails, stones, iron wire and other hard objects, so as to avoid injury accidents. 6. Probation personnel are forbidden to wear gloves. When feeding materials, they should stand on the side of the crusher so as to avoid rebounding sundries and hit the face. When crushing long-stem crops, they must not be held too tightly to prevent accidents. 7. During the operation process, pay close attention to the working conditions of the crusher. If any vibration, abnormal noise, excessive bearing and machine parts temperature, and external spray are detected, the machine should be shut down immediately for inspection. Troubleshooting can be continued. . 8. When the jam occurs and the load is too heavy, the machine should be shut down immediately. It is forbidden to use a stick or a hand to force the material to avoid injuring the arm and damaging the machine. After each shift, the crew must be checked and maintained to ensure that the crew is in good condition. Anti-Dust Smog Virus Kn95 Mask Kn95 Half Face Mask,50pcs Kn95 Face Mask,Anti-Dust Smog Virus Kn95 Mask,Anti-Dust Smog Virus Kn95 Mask Dongguan Keyutai Mask Co., Ltd. , https://www.maskkytai.com