Juvenile skin is the inevitable process of abnormal growth and development. Only by periodically removing old skin, can it gradually develop into a cocoon. The environmental conditions required for molting are strict and the following technical points must be observed.

First, the skin. The scorpion reproduces as an ovary and the larvae are born from the mother. After a few days, she does not eat and she survives on the mother's egg yolk. After about 5 days, she crawls down the mother's back after a skin-to-skin. After the mother has used a tail thorn to clean up the small raccoon skin on the back, the baboon climbs back to the back of her mother’s cub, about 5 days later. The second-instar climbs down the mother's back and can find food independently. At this time, mothers should be fed in time. If they are short of food, their mothers will eat their own oysters. Pregnancy must be fed with sufficient fat before puerperium production, and the alfalfa humidity should be maintained at 15-20%.

The second-instar climbed down the back of the mother and drilled automatically from the prepared plastic eyelet to the lower layer. The bottom layer was equipped with multiple layers of tiles. Multiple holes were drilled on the surface of the earth pile, and a few insect hopper trays were built with cement at the corner of the ground plane. Put about 10 millimeters of small yellow mealworms and small earthworms as bait for scorpions. Put some cornmeal and wheat bran into the dish for survival. The second-instar carcass is about 1.5 cm long. It has strong activity and fast growth. After about one month, it can pick up the second time and provide more life for the little cricket. Sites, gap tiles, and reduced density, as long as the skin has suitable environmental conditions, can prevent mutual interference, biting, kill each other, eat small, the second instar breeding is difficult, the quality of the skin is also It is related to the success or failure of breeding.

Tsai's life requires six times of molting. The key lies in the quality of the feed. Humidity should be maintained at 15-20%, air humidity is 70-80%, temperature is 32-39°C, and the density should be appropriate. Each time the molting is smooth or not It is also an important part of raising the efficiency of breeding.

In the summer and summer heat seasons of each year, if the weather is dry, add water to the reservoir above the mound, cover the plastic sheeting under heavy rain, and do not cover under the drizzle.

Second, prevent escape. The second-inhabited eagle has a greater ability to escape than other ages. There are gaps in the glass joints on the pool side, and the ash is glued on the glass. Small holes can be climbed out at the corners. Small cymbals can also be crushed like a ladder. Hanging out and fleeing, a little careless, can escape a lot at night.

Third, the age. The age of the quail is divided by the moltings. The larvae are counted from the mother's birth; about 3-5 days on the mother's back, the first skin is the second age, and the body length is about 1.5 centimeters; the second time in the months of August and September. The skin is three years old and its body length is about 2 cm. In June of the following year, it is the third skin, the fourth age, and the body length is about 3 cm. In August of the following year, the fourth skin is the fifth instar, and the body length is about 4 cm. In June of the same year, the fifth skin was 6 years old and its body length was about 5 cm. In the third year of August, the sixth skin was 7 years old, and its body length was about 6 cm. If it is warmed by plastic cloth in the first half of October, it can be warmed slowly with plastic sheet after the next year, shortening the hibernation time and allowing the young cubs to grow in advance.

Fourth, natural temperature. Xiaoshutaishu is a breeding season for pre-eclampsia. During the period from grazing to white dew, the pupa shed should only be constructed in a sunny place. The temperature must be appropriate. As long as the mound regulates the dryness and humidity, the density is appropriate, and the foodstuff is sufficient, invincible and young.蝎 will be able to smoothly through the difficulties.

pidural and spinal combined anesthesia puncture, Epidural Needle ,Introducer Needle, Infusion Pumps ,trachea cannula,

Components FOR AS-E/S FULL KIT

(AS-E/S) Combined spinal Epidural Anesthesia puncture package/kit
(AS-E) Epidural anesthesia puncture package/kit
(AS-S) Spinal anesthesia puncture package/kit
(AS-N) Nerve Anesthesia puncture package/kit

Y-valve Connector
Blood Inflation Balloon

Other Medical Product

Epidural Needle,Introducer Needle,Infusion Pumps,Tracheal Cannula,Y-valve Connector,Blood Inflation Balloon

Anesthesia Medical Co., Ltd. , http://www.sinoanesthesia.com