1. The steam sandwich pot should first inject a small amount of clean water into the sandwich pot before opening the material, open the “bottom ball valve”, and then open the “intake valve”. When the cold air in the interlayer of the pot is drained, close the “ball valve”. When the pressure gauge pointer rises to the “working pressure” set by the sandwich pot, the “safety valve” is set to automatically deflate when it reaches the “pressure relief value” specified by the equipment. At this time, the “intake valve” can be closed. Stop supplying steam.

2. Brush the steam sandwich pot and put in the material. Slowly open the “intake valve”. When the material reaches the required temperature and the predetermined heating time, close the “intake valve”. Open the drain valve, release the steam, make the pressure in the sandwich pot zero, tiltable (including tilting stirring) sandwich pot, turn the hand wheel, tilt the pot, and in and out of the discharge (vertical steam sandwich pot directly from the pot The bottom of the body can be discharged.) At this point, one job is completed.

The electric heating sandwich pot is very convenient to use, as long as there is electricity, it can be plugged in at any time to start up. It is a necessity in small and medium food factories, mass dining occasions and various beverage production lines. Therefore, in order to extend the life of the sandwich pot, we should pay attention to the following points when using electric heating sandwich pots?

1. First, the rated voltage of the electrically heated sandwich pot should be consistent with the voltage used.

2. When using the stainless steel sandwich pot, the inner pot should be cleaned in time after use. When cleaning, avoid the hard object scraping the bottom of the inner pot. After washing, the outer surface of the inner pot should be watered. Wipe clean and put it in the outer pot;

3, electric heating sandwich pot electric frying is not suitable for cooking acid, alkali food, but can not be placed in a corrosive environment;

4. If you want to take out the inner pot, you should take it out in case of power failure, otherwise there will be danger of burning the electric hot plate;

5, the mezzanine pot should ask the relevant professional maintenance when there is a problem, can not be dismantled.

6. During the use, the grounding conductor of the electric heating sandwich pot should not be easily removed, because the grounding measure is the last protection measure to prevent electric shock.

7. The power must be turned off before cleaning or moving the electric heating sandwich pot. When cleaning the outer casing, wipe it with a clean rag. It is strictly forbidden to flush the outer casing and the electrical box with the jet of water.